Request further information from ZETA CORPORATION.

Configuring a Zeta Rod System
for Treatment of Evaporative Coolers

From this page you can assemble the information required to receive a quotation from Zeta Corporation for a Zeta Rod system for your evaporative coolers. Refer to the illustration below.
Your name:
Your company or organization:
Your email address:
Your telephone number with area code:
Evaporative Coolers (A): please enter the total number of coolers and their rated cooling capacities.
	Number of coolers:
	Total cooler capacity: cfm
Water Source and Quality (B): please select your water source and provide some information about its quality (TDS or total hardness) and cost.
	Source: Municipal Well
	Total dissolved solids (TDS): ppm OR Hardness: grains
Water Distribution System (C): please provide the following information about the water distribution system. This information will be used to determine whether a Zeta Rod electrode can be installed directly into a pipe elbow or tee, or whether a reaction chamber is required.
	Pipe material: Metallic Non-metallic	Pipe diameter: inches
Storage tank (D): if water is distributed to the coolers from a storage tank, please provide the following information which will be used to determine whether a Zeta Rod electrode can be installed in the tank.
	Tank volume: gal OR Tank Dimensions: X X feet
	Tank material: Metal Other
Water recirculation or disposal from coolers (E): indicate whether water is recirculated from the coolers, if there is a bleed system on your coolers, and whether water is disposed to the sewer system.
	Bleed: check here if water is bled from the coolers to a sanitary sewer or other destination.
	Recirculation: check her if water is recirculated through the distribution system.
Pipe run distance between storage tank or water supply line and furthest cooler (F): feet
Comments: any other information that may assist us in configuring a system for your application.

[HOME] [TOUR] [TECHNOLOGY] [APPLICATIONS]
[COMPANY] [SEARCH] [SITE MAP]